Xantrex Technology HW 1000 manual Freedom HW, Color AC Wire

Table 1-4Required AC wire size vs. required breaker rating

	Required Breaker Size	Required Wire Size
Freedom HW	30 A maximum	10 AWG

There are two knockouts on the front panel for AC input and output wiring.

CAUTION: Equipment damage

The AC wiring terminal block is split into input and output sections. Damage to the inverter will occur if the unit is wired incorrectly.

When making the AC input and AC output connections, observe the correct color code for the appropriate AC wire, as described in Table 1-5.

Table 1-5Color codes for typical AC wiring

Color	AC Wire
Black or Brown	Line
White or Blue	Neutral
Green, Green/Yellow,	Ground
or bare copper

AC Input Connections

1.Ensure that AC and DC power are both OFF.

2.Install the required circuit breaker in the AC output panel supplying the unit (See Figure 1-6 on page 1–21).

3.Remove the AC wiring compartment cover.

4.Remove the left-hand side AC wiring knockout from the front panel of the unit (see Figure 1-5 on page 1–17).

5.Locate the terminal block.

The two input terminals are labeled as follows:

•AC Input (L)

•AC Input (N)

A separate screw is provided to connect the AC input ground (see

Figure 1-5 on page 1–17).

1–16 975-0468-01-01

This guide for use by qualified installers only