Installing Batteries
myPower GO requires four rechargeable or alkaline AA batteries, which are housed on the bottom side of the unit. As myPower GO doubles as a battery charger, rechargeable batteries can be recharged in the unit.
(Please note that alkaline and rechargeable batteries should not be used together.)
1.Push down on the lever above the USB port, slide the cover in the direction of the arrow, and then lift the cover to remove
(as shown).
2. Insert the batteries in the | Push down | Slide cover forward |
directions indicated. | and lift | |
|
|
3.Replace the cover.
4.Press the TEST button. All LEDs will light to indicate the batteries are installed properly. As the batteries are drained to charge your portable device(s), the LEDs will turn off in sequence.
4