Emerson CF3100AGW00 Light Kit Installation, Switch Cover Installation, HALOGEN BULB Type GY8

Light Kit Installation

1.Install the 50-watt (maximum) bi-pin (Type GY8) halogen bulb (supplied) into the light kit socket (Figure 18). Do not touch the glass bulb; use the porcelain base to screw in the bulb, or wear gloves.

CAUTION: To avoid risk of burns or other injury, assure power is off before attempting to install or replace the 50-watt (max.) bi-pin halogen bulb.

CAUTION: To not touch 50-watt (max.) bi-pin halogen bulb with bare hands. Fingerprints may result in shorter bulb life. Remove fingerprints with alcohol.

LIGHT KIT

ASSEMBLY

LIGHT KIT

SOCKET

50-WATT (Max.) BI-PIN

HALOGEN BULB (Type GY8)

Figure 18

2.Place the glass onto the light kit assembly aligning the three flat areas on the top flange of the glass shade with the three pins on the inside of the assembly (Figure 19). Then turn the glass clockwise until it stops turning.

LIGHT KIT

ASSEMBLY

PIN (3)

GLASS SHADE

FLAT AREA (3)

Figure 19

3.Your ceiling fan is now installed and wire to be controlled by your remove control system.

Switch Cover Installation

If no light kit is desired, continue with non-light switch cover installation.

NOTE: Do not install the 50-watt (max.) bi-pin halogen bulb or unhook the 50-watt (max.) bi-pin halogen bulb from light kit socket.

1.Place the non-light switch cover onto the light kit assembly aligning the three flat areas on the top flange of the non-light switch cover with the three pins on the inside of the assembly (Figure 20). Then turn the non-light switch cover clockwise until it stops turning.

LIGHT KIT

ASSEMBLY

PIN (3)

NON-LIGHT

SWITCH COVER

FLAT AREA (3)

Figure 20

2.Your ceiling fan is now installed and wire to be controlled by your remove control system.

10