Emerson CF3100AGW00 owner manual U.L. Model No. CF3100, Head Screws, Clevis Pin

7.Connect the 4-pin connector from the decorative light kit assembly to the 4-pin connector of the switch housing (Figure 3).

8.Connect the switch housing blue wire single-pin connector to the black wire single-pin connector from the light kit assembly; connect the switch housing white wire single-pin connector to the white wire single-pin connector from the light kit assembly (Figure 3). Be sure all wire connectors are fully engaged.

12.Carefully turn over the partially assembled ceiling fan and place onto the flat surface of the styrofoam.

13.Obtain the hanger ball/downrod assembly and remove the hanger ball by loosening the setscrew in the hanger ball until the ball falls freely down the downrod (Figure 5). Remove the pin from the downrod, then remove the hanger ball. Retain the pin and hanger ball for reinstallation in Step 24.

LIGHT KIT ASSEMBLY

LIGHT KIT ASSEMBLY

BLACK WIRE CONNECTOR

SWITCH HOUSING BLUE

WIRE CONNECTOR

SWITCH HOUSING WHITE

WIRE CONNECTOR

4-PIN CONNECTORS

SWITCH HOUSING

LIGHT KIT ASSEMBLY WHITE WIRE CONNECTOR

Figure 3

CAUTION: Before installing and tightening the screws, be sure there are no wires pinched between the switch housing and the light kit assembly.

9.Make sure all wires, single-pin and 4-pin connectors are inside the switch housing, then position the light kit assembly on the switch housing so that the holes line up.

10.Attach the light kit assembly to the switch housing using the three #8-32 x 10mm pan head screws (supplied). Do not tighten screws at this time. Position the light kit assembly onto the switch housing, making sure all wires are not pinched (Figure 4).

11.Rotate the light kit assembly clockwise to engage the keyhole slots. Secure all three screws at this time (Figure 4).

NOTE: Be sure wires and connectors are not pinched under the decorative light kit assembly before securing the light kit assembly.

	#8-32 x 10mm PAN
KEYHOLE SLOT (2)	HEAD SCREWS (3)

LIGHT KIT

ASSEMBLY

PIN

HANGER BALL

DOWNROD SETSCREW

Figure 5

NOTE: The 16” downrod furnished with the ceiling fan provides the minimum recommended floor-to-fan blade clearance for a 9-foot ceiling.

14.Separate, untwist and unkink the black, white and blue motor wires and the yellow uplight lead. Route these wires through the downrod.

15.Slide the downrod down the wires and seat the downrod in the motor coupling (Figure 6).

16.Align the clevis pin holes in the downrod with the holes in the motor coupling. Install the clevis pin and secure with the hairpin clip (Figure 6). The clevis pin must go through the holes in the motor coupling and the holes in the downrod. Push the straight leg of the hairpin clip through the hole near the end of the clevis pin until the curved portion of the hairpin clip snaps around the clevis pin. The hairpin clip must be properly installed to prevent the clevis pin from working loose.

DOWNROD

HAIRPIN

CLIP

SETSCREW

MOTOR

COUPLING

CLEVIS PIN

DOWNROD

HAIRPIN	CLEVIS PIN
CLIP

MOTOR	SETSCREW
COUPLING

		Figure 6
Figure 4	5	U.L. Model No.: CF3100