Emerson CF3100AGW00 owner manual One-Pin

WARNING

It is critical that the clevis pin in the motor coupling is properly installed and the setscrew securely tightened. Failure to verify that the pin and setscrew are properly installed could result in the fan falling.

17.Install the setscrew (supplied) in the motor coupling and tighten using the 5/32” setscrew wrench (supplied) (Figure 6).

18.Engage the one-pin yellow wire from the motor housing to the one-pin black wire of the decorative uplight kit. Engage the one-pin white wire from the motor housing to the one-pin white wire of the decorative uplight kit (Figure 7).

DECORATIVE

UPLIGHT KIT

WHITE WIRE

ONE-PIN	DECORATIVE
CONNECTOR	UPLIGHT KIT
	BLACK WIRE
DECORATIVE
UPLIGHT KIT
MOTOR HOUSING
WHITE WIRE
MOTOR HOUSING
YELLOW WIRE

Figure 7

19.Carefully tuck all wires and connectors in the decorative uplight kit assembly before placing onto the motor housing. Align the four holes in the decorative uplight kit assembly onto the motor housing.

20.Secure the decorative uplight kit assembly to the motor housing using four #8-32 x 10mm pan head screws (supplied) (Figure 8).

21.Install three 15-watt (minimum) (not supplied) candelabra light bulbs in the uplight sockets (Figure 8).

DECORATIVE

#8-32 x 10mmUPLIGHT KIT PAN HEAD SCREW (4)

15-WATT (min.)

CANDELABRA LIGHT BULBS (3)

22.16” Or Optional Longer Downrod Installation: Slide the decorative scrolls over the 16” downrod to rest upon the decorative upper housing (Figure 9) To secure the decorative scrolls to the downrod, tighten the Philips head screw in the decorative scroll collar.

	16" DOWNROD
PHILIPS HEAD	DECORATIVE SCROLL
SCREW	COLLAR
	DECORATIVE
	SCROLLS
	DECORATIVE
	UPPER HOUSING

Figure 9

23.Position the ceiling cover over the downrod. Be sure the cover is oriented correctly, with the large opening at the top (Figure 10).

24.Reinstall the hanger ball on the downrod as follows. Route the motor leads through the hanger ball and slide the hanger ball over the downrod (Figure 10). Install the pin through the holes at the top of the downrod and slide the hanger ball up the downrod, aligning the ball so the pin is captured in the groove in the top of the hanger ball. Pull the hanger ball up tight against the pin and securely tighten the setscrew in the hanger ball. A loose setscrew could create fan wobble.

25.The blue, black, white, and yellow leads exiting the downrod are 80-inches long. Before installing the fan, measure up approximately 6 to 9-inches above the ball/downrod assembly. Cut off excess leads and strip back insulation 1/2-inch from end of leads.

Figure 8 6 U.L. Model No.: CF3100