Grinding mode setting:
| GRIND | 9 |
| |||
Figure 2 | 13 |
|
|
|
| 10 |
|
|
|
| |||
12 | 11 |
| ||||
|
| |||||
To change to Grinding Mode, rotate the Shade Control Knob counterclockwise to Grind. This turns off the shade function so the helmet lens stays clear. Use this function to provide protection while grinding.
CAUTION: Be sure to set the helmet to the proper shade setting before welding again.
Adjusting Headband
Adjust the Headband so that the helmet is seated securely on your head as low as possible and close to your face.
Ratcheting |
|
|
Headband |
|
|
Knob |
| Tension |
| Top | |
| Adjustment | |
| Strap | |
| Knob | |
|
|
Figure 3
Adjust the Headband width by turning the Ratcheting Headband Knob to make sure the Front Cover Lens is aligned with your eyes.
Adjust the Headband height by tightening or loosening the top strap until the Helmet fits snug on your head.
Once the Headband is properly adjusted, lower the Helmet over your face until the proper angle is found. Then turn the Tension Adjustment Knobs on either side of the helmet, locking the helmet’s angle in place. See Figure 3.
Product Features
Time Delay and Sensitivity:
At the moment the welding operation is started, the filter screen automatically changes from clear to dark.
The operator can vary the amount of time it takes the filter to return to a clear state and the sensitivity of the sensor using the controls inside the helmet.
Dark to Clear Adjustment Switch
Adjusts the speed the lens changes.
In FAST position: .25
In SLOW position: .65
ANSI
| SENSITIVITY | DELAY TIME | ||||
| LOW < |
| > HIGH | SLOW < |
| > FAST |
|
|
| ||||
| Sensitivity Adjustment Switch | |||||
Figure 4 | Adjusts the amount of light needed to | |||||
activate the lens to darken. | ||||||
The Sensitivity setting changes the amount of light needed to make the filter react.
Solar Cells:
This Welding Helmet utilizes high performance solar cells as power supply, and has two
Item 67854 | For technical questions, please call | Page 7 |
91214 |
|
|