Harbor Freight Tools 67854 operating instructions Common Problems Remedies

Shades

User-selectable variable shades from 9 to 13 are adjusted at the turn of a shade knob (shade variable). This product is in full conformity with related DIN, ISO, EN379 safety standards and ANSI Z87.1-2003 standard.

Filters

The ultra high performance of UV and IR Auto-Darkening filters provides to user’s eyes and face full protection against UV and IR radiation during entire welding process, even in clear state. The UV/IR protection level is up to shade 16 at all times.

Magnifying Cheater Lens

Figure 5

A Cheater Lens (sold separately) can be attached to the inside of the helmet by unhooking the wire bar at the bottom of the Inside Lens Cover, sliding the Cheater Lens in place, then securing it with the wire bar.

Common Problems and

Remedies

1.Irregular Darkening or Dimming

a.Headband has been set unevenly on both sides of helmet (unequal distances from the eyes to filter’s lens).

b.Reset Headband to reduce difference in distances to filter, if necessary.

2.Auto-Darkening Filter Does Not Darken Or Flickers

a.Front Cover Lens is soiled or damaged (change the cover lens).

b.Sensors are soiled (clean surface of the sensors).

c.Welding current is too low (turn Dark to Clear Adjustment switch to the “SLOW” position, if necessary).

3.Slow Response

Operating temperature is too low (do not use at temperatures below 23° F).

4.Poor Vision

a.Front/Inside Cover Lens and/or filter soiled (change it).

b.Insufficient ambient light.

c.Shade number is incorrectly set (reset shade number).

5.Welding Helmet Slips

Headband is not adjusted properly (must be lowered).

Warning: Stop using the Helmet immediately if any of the mentioned problems cannot be corrected.

Page 8	For technical questions, please call 1-800-444-3353.	Item 67854
		91214