Dometic 3300, 3400 owner manual

Page 5

FOR MODEL 3400 TOILET WITH REMOTE SWITCH OPERATION, see page 7 for wall switch installation instructions.

STEP 9: WITH THE ELECTRICAL POWER OFF, route #14 gauge stranded copper wire from 12 VDC ground and positive 12 VDC from the fuse panel through a 7- or 8-amp fuse or circuit breaker. Leave at least 30 inches (305 mm) of wire for connecting to toilet (fig. 9).

Fig. 9

STEP 10: Connect the holding tank to the bottom of the discharge flange.

STEP 11: Slide the four T-bolts into the slots of the floor flange. Install the flange gasket over the T-bolts (fig. 10).

Fig. 10

STEP 12: Install floor flange adapter with words “THIS SIDE UP” facing up. Tighten adapter to floor flange using four flat washers and hex nuts. Tighten in criss-cross pattern (fig. 11).

Fig. 11

IMPORTANT: If replacing an existing toilet that uses a 2-bolt floor flange, drill two 5/16-inch dia. holes in old floor flange that align with two additional holes in floor flange adapter. Use two #10 or 12 x 1-1/2-inch wood screws and washers for these drilled holes, and two T-bolts with flat washers and nuts to fasten flange gasket and floor flange adapter to old floor flange. Do not use old hardware or seal.

STEP 13: Temporarily set the toilet in place on the floor flange (fig. 14).

Fig. 14

STEP 14: Mark the holes for the two toilet mounting bolts (fig. 15).

Fig. 15

STEP 15: Pick up toilet and set aside. Drill 3/16-inch pilot holes in the floor (fig. 16).

Fig. 16

5

Page 4 Page 6
Image 5
Page 4 Page 6
Contents
Dometic Corporation Sanitation Systems ConcertoOrdering Parts Table of ContentsToilet Model Identification System Requirements Concertotm Toilet DimensionsToilet Installation Instructions Page Page Page Remote Flush Switch Components Model 3400 Remote Flush Switch InstallationImportant Information Before Operation Switch ToiletElectronic Flush and Forget Operation Toilet ControlsService Automatic Flush Operation Timing ChartOperating Instructions NormalManual Flush Operation Proper Cleaning and MaintenanceWinterizing Deodorants and Special TissueSpare Parts Description Part Number QuantityBase Assembly Components Remote Flush SwitchFlush Mechanism Components Flush Handle Components Control Module12VDC Toilet System Electrical SpecificationsError Codes TroubleshootingStatus Light Color Function Status Light No. of Flashes Pause ConditionTroubleshooting cont’d Symptom 3. Flush valve will not close Symptom 6. Water will not stay in bowl Series with flush handle Series with remote flush switch Wiring DiagramsMaster Sanitation Distributors Customer ServiceExclusions MANUFACTURER’S THREE-YEAR and TEN-YEAR Limited WarrantiesImplied Warranties Other Rights
Top Page Image Contents