Harbor Freight Tools 40132 operating instructions

Page 3

7.DRESS PROPERLY. Do not wear loose clothing or jewelry as they can be caught in moving parts. Protective, electrically non-conductive clothes and non-skid footwear are recommended when working. Wear restrictive hair covering to contain long hair.

8.USE EYE AND EAR PROTECTION. Always wear ANSI approved chemical splash goggles when working with chemicals. Always wear ANSI approved impact safety goggles at other times. Wear a full-face shield if you are producing metal filings or wood chips. Wear and ANSI approved dust mask or respirator when working around metal, wood, and chemical dusts and mists.

9.DO NOT ABUSE THE POWER CORD. Do not yank it to disconnect it from the receptacle. Do not carry tools by the cord.

10.DO NOT OVERREACH. Keep proper footing and balance at all times. Do not reach over or across running machines.

11.MAINTAIN TOOLS WITH CARE. Keep tools sharp and clean for better and safer perfor- mance. Follow instructions for lubricating and changing accessories. Inspect tool cords periodically and, if damaged, have them repaired by an authorized technician. The handles must be kept clean, dry, and free from oil and grease at all times.

12.DISCONNECT POWER. Unplug when not in use, before servicing, and when changing accessories.

13.REMOVE ADJUSTING KEYS AND WRENCHES. Make it a habit to check that keys and adjusting wrenches are removed from the tool or machine work surface before plugging it in.

14.AVOID UNINTENTIONAL STARTING. Be sure the switch is in the OFF position when not in use and before plugging in. Do not carry any tool with your finger on the trigger, whether it is plugged in or not.

15.OUTDOOR EXTENSIONS CORDS. When the equipment is operated outdoors, use only extension cords intended or outside use. See chart under “Extension Cords: for the proper AWG rating depending on the length of the cord(s) being used.

16.STAY ALERT. Watch what you are doing, use common sense. Do not operate any tool when you are tired.

17.CHECK DAMAGED PARTS. Before using any tool, any part that appears damaged should be carefully checked to determine that it will operate properly and perform its intended function. Check for alignment and binding of moving parts; any broken parts or mounting fixtures; and any other condition that may affect proper operation. Any part that is damaged should be properly repaired or replaced by a qualified technician. Do not use the tool if any switch does not turn on and off properly.

18.GUARD AGAINST ELECTRIC SHOCK. Prevent body contact with grounded surfaces such as pipes, radiators, ranges, and refrigerator enclosures.

#40132

Page 3

Image 3
Contents Compressor Duty Motor 1 HP Model Specifications Safety Warning & CautionsSave this Manual Page Mounting the Motor UnpackingPlease Read the Following Carefully Wiring