Pilot
Valve
8.Pilot Valve. Open the Pilot Valve before starting the engine. It relieves resistance on the engine to make starting easier. It is shown in the open position above. Push the pin over to one side to close it.
Equipment Set Up
Read the entire Important Safety Information section at the beginning of this manual including all text under subheadings therein before set up or use of this product.
Note: For additional information regarding the parts listed in the following pages, refer to the Assembly Diagrams near the end of this manual.
Unpacking
Note: Do not use the air cleaner to lift or move the compressor. It is not de- signed to withstand such force.
When unpacking, make sure that the item is intact and undamaged. If any parts are missing or broken, please call Harbor Freight Tools at
Mounting
1.The compressor may vibrate strongly during use, so mounting is needed to prevent movement.
2.Before use, mount the compressor securely using all four mounting holes to a solid, level surface, such as a concrete slab or truck bed.
3.Rubber pads (not included) may be used at the mounting points to reduce vibration.
Equipment Oil Fill
IMPORTANT. To prevent property damage and voiding of the warranty:
Before first use, fill the compres- sor with compressor oil as follows:
1.Remove the Breather Vent (22) and fill with 1.37 quarts of premium quality
SAE
2.Check the oil level at the Oil Sight Glass. The oil level should be at the middle of the Glass. Add or drain oil as needed until it is at the proper level.
3.Thread the Breather Vent (22) back into place, being careful not to cross- thread it or strip its threads.
REV 09c
SKU 65204/ 99918
For technical questions, please call | Page 9 |