OPERATING INSTRUCTIONS
1. Adding More Water To Toilet Bowl
Pull up the handle until the desired water level is attained. To prevent overflowing the toilet, a timer inside the control module limits the amount of water that can be added.
2. Flushing The Toilet
Push the handle down for a moment, then release it. Holding the handle down will not prolong the flush cycle nor start a new flush cycle. The lever must be allowed to return to the OFF position before another flush can occur.
3. Selecting Automatic Water Levels
The Water Level switch is located under the access cover. Carefully lift up on the front of the cover to access the Water Level switch. There are three water refill levels available. The
To reinstall the access cover, set the cover on top of the toilet and press down. This will lock the cover in place and prevent it from coming loose during rough travel.
LOW Level
Use this setting to conserve water. This level also may be desirable to reduce the chance of water splashing out of the bowl during sudden stops and starts or when traveling. If more water is needed for flushing, lift up on the flush handle. Water flow will stop after nine seconds to prevent overflow.
MID Level
Use this position to keep the toilet bowl clean, especially when family and friends may be using the toilet. If more water is still needed for flushing, raising the flush lever will provide up to six seconds of additional water refill time.
HIGH Level
Use this position if the MID level does not provide a clean toilet bowl. This position is not recommended while the vehicle is underway. If more water is still desirable for flushing, raising the flush handle will provide up to three seconds of additional water refill time.
4. Mode Switch
The Mode switch is located on the right side of the printed circuit board. It lets you switch between three function settings:
NORMAL
Use this setting for flushing the toilet.
SERVICE
Use this position for cleaning the toilet bowl and flush ball seal. The flush ball will open automatically and remain open in this position. Lifting up the flush handle provides water.
MANUAL OVERRIDE
Use this position to flush the toilet manually in the event of power or battery failure. This switch disconnects the electronic brake in the flush valve motor, and allows manual flushing via the override access hole in the side of the vitreous china base.
Note: The control module allows 15 seconds of water for cleaning. If more water is required, return the switch to the NORMAL position, then back to the SERVICE position.
A safety circuit in the control module monitors flush ball operation. If foreign objects or low voltage prevent the flush ball from closing, this circuit prevents personal injury or damage to the flush valve motor. If this condition occurs, reset the control module by placing the Mode switch into the SERVICE position temporarily, then returning it to the NORMAL position.
4