Harbor Freight Tools 93762 operating instructions See Figure W

5.Turn the Power Switch (164) to its “ON” position. (See Figure W.)

6.CAUTION! Cut only flat workpieces when the Bandsaw is in its vertical position. Never attempt to cut pipes or other round objects with the Bandsaw in its vertical position.

7.Before cutting, turn on the Bandsaw and check for excessively loose Saw Blade (82) tension or machine vibration. If this is found, turn off the Bandsaw and correct the problem before using. (See Figure W.)

8.Set the workpiece on the Vertical Cutting Plate (189), making sure to keep down- ward pressure on the workpiece throughout the cutting process.

(See Figure W.)

9.When cutting a large workpiece, make sure its entire length is properly sup- ported. If necessary, use a roller stand (not included) with a larger workpiece.

10.Allow the Saw Blade (82) to turn up to full speed before feeding the workpiece into the Saw Blade. (See Figure W.)

11.WARNING! Always keep hands and fingers safety away from the cutting area.

12.Feed the workpiece into the Saw Blade (82) gradually. Do not force the Bandsaw to remove material faster than it is designed to cut. (See Figure W.)

13.Never attempt to remove material stuck in the moving parts of the Bandsaw while it is plugged in and running. Turn off the Bandsaw if the workpiece is to be backed out of an uncompleted cut.

SAW BLADE

(82)

VERTICAL CUTTING PLATE

(189)

POWER SWITCH

(164)

FIGURE W

BODY FRAME

(60)

SUPPORT PLATE

(150)

LOCKING PIN (153)

SKU 93762 For technical questions, please call 1-800-444-3353. Page 23