Harbor Freight Tools 93762 operating instructions Basic Bandsaw Operation -- Horizontal Position

14.Once the cut is made, turn the Power Switch (164) to its “OFF” position. Then, unplug the Power Cord Plug from its electrical outlet. (See Figure W.)

15.Wait until the Saw Blade (82) comes to a complete stop. Then, remove the work- piece and scrap material from the Vertical Cutting Plate (189).

(See Figure W.)

16.Remove the Locking Pin (153) and turn the Support Plate (150) to the left. Then, lower the Body Frame (60) to its horizontal position. (See Figure W.)

Basic Bandsaw Operation -- Horizontal Position:

1. WARNING! Always wear ANSI-approved safety impact eye goggles when operating the Bandsaw.

2.Do not plug the Power Cord Plug into an electrical outlet until all neces- sary adjustments (as previously discussed in this manual) have been made.

3.Raise the Body Frame (60) to its full vertical position, making sure it locks in place by turning the Support Plate (150) to the right until it firmly locks into the Body Frame and inserting the Locking Pin (153). (See Figure W.)

4.Secure the workpiece in the Vise assembly (138, 141). When cutting a large workpiece, make sure its entire length is properly supported. If necessary, use a roller stand (not included) with a larger workpiece. (See Figure X.)

5.If cutting several workpieces at the same length, you may wish to adjust the Stock Stop (157) to the desired position. (See Figure X.)

6.Once all necessary adjustments to the Bandsaw have been made, plug the Power Cord Plug into the nearest 120 volt, grounded, electrical outlet. (See Figure X.)

SWITCH PUSH-OFF TIP

(41)

POWER SWITCH

(164)

BODY FRAME

(60)

VISE ASSY. (138, 141)

			SUPPORT PLATE
			(150)
STOCK	STOP
		LOCKING PIN	FIGURE X
(157)		(153)

SKU 93762 For technical questions, please call 1-800-444-3353. Page 24