Harbor Freight Tools 93762 operating instructions Figure AA

E.Adjust the position of the Motor (81) to obtain approximately 1/2” depression in the V-Belt (10) when applying pressure with your thumb. (See Figure Z.)

F.Tighten the Hex Bolt (70) to secure the Motor (81) in place.

(See Figure X.)

5.To lubricate the Worm Gear and Worm Shaft: The Worm Gear (17) and Gear Shaft (19) run in an oil bath Gear Box and should not require an oil change more than once a year, unless the oil becomes contaminated or a leak occurs due to improper replacement of the Gear Box Cover (14). To change oil in the Gear Box:

A.Position the Body Frame (60) in the horizontal position. (See Figure W.)

B.Remove the four Hex Bolts (11), Gear Box Cover (14), and Gear Box Gasket (15). (See Figure AA.)

C.Remove the old oil from inside the Gear Box and replace the oil using

140 weight gear oil. The new oil should just come to the edge of the Gear Box. Do not overfill. (See Figure AA.)

D.Replace the Gear Box Gasket (15), Gear Box Cover (14), and four Hex Bolts (11). (See Figure AA.)

GEAR BOX COVER
(14)	GEAR SHAFT
	(19)

HEX BOLT

(11)

FIGURE AA

WORM GEAR

(17)

6.To clean the exterior parts of the Bandsaw, use only a clean cloth and mild detergent or mild solvent to clean the body of the Saw. Do not immerse any electrical part of the machine in any liquids.

7.When the Bandsaw is not in use or when transporting the tool: Always lower the Body Frame (60) to its horizontal position and insert the Locking Pin (115)

SKU 93762 For technical questions, please call 1-800-444-3353. Page 28