UPPER SCREW (#39)
UPPER ROLLER SHEATH (#33)
FRAME
(#50)
MOVEABLE BAR
(#40)
LOWER SCREW
(#39)
LOWER ROLLER (#31) 
LOWER ROLLER SHEATH
(#33)
For illustration purposes, the saw is shown in upright position. Saw should be locked down during installation.
BACK PLATE (#46)
RIGHT SIDE
HEX SCREW (#45)
(TEMPORARILY REMOVE)
| MOVEABLE COVER |
| (#43) |
| LEFT SIDE |
| HEX SCREW (#45) |
| (TEMPORARILY LOOSEN) |
FIXED BAR | FIGURE F |
(#34) |
To Attach The Moveable Cover: (See Figure F, and Assy. Diagram.)
1.Caution: Prior to installing the Moveable Cover (43), make sure the Compound Miter Saw is disconnected from its electrical power source.
2.Use the lock button Plastic Ball (51) to secure the saw arm in its lowered position.
3.Locate the two Hex Head Screws (45) on the frame. Use the wrench provided to remove the front screw, and to loosen the rear screw a few turns.
4.Use a cross head screwdriver (not included) to remove Screw (39) and Roller (33) from the guard assembly.
5.Hold the blade guard assembly with the plastic cover down. With your other hand, rotate the spring plate clockwise approximately one turn so there is tension on the spring. Catch the rear slot in the plate under the head of rear Screw (45). Then align the holes, and install the front Screw. Tighten both, and release the guard carefully.
6.Check to make certain that the rear (forked) end of bar (40) is under the head of the screw that guides it. Now release the lock button plastic ball (51), and raise the saw arm. Align the forward slot in bar (40) with the threaded brass bushing in the spring plate. Install screw (39) and roller (33) through the slot and into the bushing.
7.Check that all screws are tightened and for correct operation of the guard. It should move downward to cover the blade as the saw is lowered.
Rev 08/06
SKU 42654 | For technical questions, please call | Page 10 |