To Make A Basic 90 Degree Cut:
1.Properly position the wood stock against the Location Board (23).
(See Figure I, and Assy. Diagram.)
LOCATION BOARD (#23)
BASE (#12) | SUPPORT FEET (#10) |
FIGURE I
2.Plug the Power Cable (93) into a grounded, three prong, 120 Volt, electrical out- let.
3.Pull out on the Plastic Ball (51), and pull down slightly on the Saw Handle (80, 83).
(See Figure H, and Assy. Diagram.)
4.Squeeze the Power Switch (82) to power the Compound Miter Saw. Allow the Saw Blade (70) to reach its maximum speed before starting the cut.
(See Figures E, G, and Assy. Diagram.)
5.Lower the Saw Blade (70) into the wood stock, pressing gently down. Do not force the tool. Allow the Saw Blade to do its work as you feed it into the wood stock. Continue with the cut until completed. Do not stop midway.
(See Figure E, and Assy. Diagram.)
6.When the cut is completed, release the Power Switch (82) and wait for the Saw Blade (70) to stop turning before raising the Saw Blade to its up position.
(See Figures E, G, and Assy. Diagram.)
7.Remove the cut wood stock from the Compound Miter Saw, and unplug the tool from its electrical power supply outlet.
SKU 42654 | For technical questions, please call | Page 13 |