To Install A Saw Blade:
1.Caution: Prior to installing the Saw Blade (70), make sure the Compound Miter Saw is disconnected from its electrical power source.
2.Caution: Never use a Saw Blade larger or smaller in diameter than
DEEP |
|
|
| CLIP |
|
|
| WASHER | |
SOCKET |
|
|
| |
|
|
| WRENCH | |
WRENCH |
|
|
| |
|
|
|
|
FIGURE C
3.NOTE: This procedure requires the use of the Deep Socket Wrench and Clip Washer Wrench tool accessories. (See Figure C.)
EXHAUST PORT HEX SCREW | FRAME (#50) |
| |
(#45) |
|
FIXED BAR
(#34)
HEX SCREW (#45)
LONG SCREW
(#37)
CLIP WASHER | BOLT (#73) |
(#71) | WASHER (#72) |
FIGURE D
4.Insert the two prongs of the Clip Washer Wrench into the two holes in the Clip Washer (71), and hold the Clip Washer in place to prevent the Shaft (62) from turning. (See
Figures C, D, and Assy. Diagram.)
5.Use the Deep Socket Wrench to unscrew and remove the Bolt (73), Washer (72), and Clip Washer (71). (See Figures C, D, and Assy. Diagram.)
REV 01/05
SKU 42654 | For technical questions, please call | Page |