Specifications
Blade Diameter | 4" | |
(67113 4” Continuous | ||
(Blade Not Included, | ||
Rim Diamond Blade | ||
Sold Separately) | ||
Recommended) | ||
| ||
Arbor Diameter | 5/8" | |
Maximum Cutting | ||
Capacity | ||
| ||
Electrical Requirements | 120 V~ / 60 Hz | |
|
| |
Tilting Head | 22.5° to 45° Bevel | |
|
| |
Blade Rated Speed | 4480 RPM | |
|
|
Unpacking
When unpacking, check to make sure that the item is intact and undamaged. If any parts are missing or broken, please call Harbor Freight Tools at the number shown on the cover of this manual as soon as possible.
Instructions for putting into use
Read the entire Important Safety Information section at the beginning of this manual including all text under subheadings therein before set up or use of this product.
To prevent serious injury
from accidental operation:
Turn the Power Switch of the tool to its “OFF” position and unplug the tool from its electrical outlet before assembling or making any adjustments to the tool.
Note: The Tile Saw features a
and is easy to clean. Its efficient design returns water directly to the reservoir and is accurate enough for most ceramic tile, quarry tile, marble, terra cotta, and slate jobs.
Assembly
To Install The 4” Diamond Tile Saw Blade:
1.WARNING! Make sure the Power Switch (4) of the Tile Saw is in its “OFF” position and its Power Cord (11) is unplugged from the electri- cal outlet prior to performing any assembly.
2.Remove the Screw (16) that holds the Table (1) in place and left the Table until the three catches at its midsection clear the Table’s under- side. Then remove table complete- lyh. (See Figure 2, next page.)
3.Remove the Nut (37) attached to the Motor (32) arbor. Then remove the Outer Flange (36). See Figure 3, next page.)
4.WARNING! Install Blade (67113 4” Continuous Rim Diamond Blade is sold separately) with directional arrow visible from Water Tray side. Slide Blade in and up from the under- side slot in the Table, then over arbor and rear hub flange. (See Figure 3.)
5.Attach Outer Flange and secure Nut over arbor. Turn Nut clockwise until tight. Do not overtighten. (See Fig- ure 3.)
6.Disconnect Guard Stand (24) from Guard Assembly. Slide Stand’s unthreaded end through slot under
SKU 3733 | For technical questions, please call | Page 12 |