2.Fill the Body with water. CAUTION:
Make sure the water level is high enough to cover the lower edge of the Blade but not above the maxi- mum water level as indicated by the arrow.
3.NOTE: The Table may be tilted to make 22.5 Degree or a 45 Degree beveled cuts. To do so, extend the two Legs (29) underneath the Table. Place the legs into upper or lower sections of the supports to achieve the desired bevel.
Table (1)
position and unplug the Power Cord from its electrical outlet.
To Make Mitered Cuts:
1.To make a mitered cut, place the An- gle Gauge (21) against the Rip Fence
(7). Then position the workpiece against the Angle Gauge, and slowly feed the workpiece into the Blade.
2.When finished making the angled cut, turn the Power Switch to its “OFF” position and unplug the Power Cord from its electrical outlet
Pole (29)
FIGURE 5
Table (1)
FIGURE 6
Pole
(29)
4.Place the workpiece to be cut against the Rip Fence (7), and slowly feed the workpiece into the Blade.
5.When finished making the beveled cut, turn the Power Switch to its OFF”
Maintenance And
Servicing
Procedures not specifically explained in this manual must be performed only by a qualified technician.
To prevent serious injury
from accidental operation:
Turn the Power Switch of the tool to its “OFF” position and unplug the tool from its electrical outlet before performing any inspection, maintenance, or cleaning procedures.
To prevent serious injury from tool failure:
Do not use damaged equipment. If abnormal noise or vibration occurs, have the problem corrected before further use.
SKU 3733 | For technical questions, please call | Page 16 |