Bryant R-410A warranty SPECIFICATIONS Continued

SPECIFICATIONS Continued

UNIT SIZE-SERIES			042-A		048-A		060-A
Operating Weight (Lb)			215		217		278
ELECTRICAL
Unit Volts— Hertz— Phase				208/230-60-1
Operating Voltage Range*				187-253
Compressor— Rated Load Amps			19.9		24.4		30.1
		Locked Rotor Amps	127.0		131.0		172.0
Condenser Fan Motor— Full Load Amps			1.10		1.40		1.40
Min Unit Ampacity for Wire Sizing			24.4		26.7		35.9
Min Wire Size (60°C Copper) AWG†			10		8		8
Min Wire Size (75°C Copper) AWG†			10		10		8
Max Wire Length (Ft) (60°C Copper)‡			77		97		80
Max Wire Length (Ft) (75°C Copper)‡			73		59		76
Max Branch Circuit Fuse or
Circuit Breaker Size (Amps)			40		50		60
COMPRESSOR & REFRIGERANT
Compressor— Type					Scroll
		Manufacturer			Copeland
Temperature & Current Protection					Internal Line Break
Refrigerant— Type					Puron® (R-410A)
	Amount (Lb)		6.33		6.83		7.93
CONDENSER COIL & FAN
Coil Face Area (Sq Ft)			12.16		12.16		18.3
Fins per In.— Rows— Circuits			25— 1— 2		25— 1— 2		25— 1— 3
Fan Motor— HP (PSC) & RPM			1/5 & 825		1/4 & 1100		1/4 & 1100
Volts— Hertz— Phase				208/230-60-1
Condenser Airflow (CFM)			2800		3400		3400
OPTIONAL EQUIPMENT
Support Feet					KSASF0101AAA
Coastal Filter					KAACF0801MED
Time Delay Relay					KAATD0101TDR
Cycle Protector					KSACY0101AAA
Crankcase Heater					KAACH1201AAA
Start Assist— Capacitor/Relay Type				KSAHS1501AAA			KSAHS1601AAA
Start Assist— PTC Type					KAACS0201PTC
TXV (Hard Shutoff)			KSATX0301HSZ		KSATX0401HSZ		KSATX0501HSZ
Piston Body					KSAPX0101PIS
Filter Drier (Suction Line) (RCD)					KH45LG141
Evaporator Freeze Thermostat††					KAAFT0101AAA
Liquid-Line Solenoid Valve					KAALS0201LLS
Winter Start Control††					KAAWS0101AAA
Low-Ambient Pressure Switch					KSALA0301410
MotorMaster® Control**					32LT660004
Ball Bearing Fan Motor (RCD)			HC38GE231			HC40GE232
Thermostat— Auto Changeover,
Non-Programmable, °F/°C,
1-Stage Heat, 1-Stage Cool					TSTATBBNAC01-B
Thermostat— Auto Changeover,
7-Day Programmable, °F/°C,
1-Stage Heat, 1-Stage Cool					TSTATBBPAC01-B
Thermidistat™ Control—
Programmable Thermostat with Humidity Control					TSTATBBPRH01-B
Builder’s Thermostat— Manual Changeover,
Non-Programmable, °F/°C,
1-Stage Heat, 1-Stage Cool					TSTATBBBAC01-B
Outdoor Air Temperature Sensor					TSTATXXSEN01-B
Backplate for Non-Programmable Thermostat					TSTATXXNBP01
Backplate for Programmable Thermostat					TSTATXXPBP01
Backplate for Builder’s Thermostat					TSTATXXBBP01
Thermostat Conversion Kit (4 to 5 wire)— 10 Pack					TSTATXXCNV10

*Permissible limits of the voltage range at which the unit will operate satisfactorily. Operation outside these limits may result in unit failure.

†If wire is applied at ambient greater than 30°C (86°F), consult Table 310-16 of the NEC (ANSI/NFPA 70).

The ampacity of nonmetallic-sheathed cable (NM), trade name ROMEX, shall be that of 60°C (140°F) conductors, per the NEC (ANSI/NFPA 70) Article 336-26. If other than uncoated (non-plated), 60 or 75°C (140 or 167°F) insulation, copper wire (solid wire for 10 AWG and smaller, stranded wire for larger than 10 AWG) is used, consult applicable tables of the NEC (ANSI/NFPA 70).

‡Length shown is as measured 1 way along wire path between unit and service panel for a voltage drop not to exceed 2%. ** Fan motor with ball bearings required.

††See low-ambient controller Installation Instructions for application.

N/A — Not Applicable.

NOTE: Copper wire must be used from service disconnect to unit. All motors/compressors contain internal overload protection.

— 5—