Festool TS 55 EQ instruction manual Using Dust Extraction

Page 16

Using Dust Extraction

The TS 55 can be used with or without a dust extraction system. The chip diverter swivels to direct the sawdust away from the work area when a dust extraction system is not used.

For best results, however, a dust extraction system (such as the Festool CT 22 shown below) should be used. Festool dust extractors have the added features of variable speed, and sensing when the saw is turned on. The vacuum will automatically start when the saw is turned on, and will remain running for a couple of seconds after the saw turns off to clear the remaining dust.

1.Insert the extractor hose into the chip diverter (36 mm inside diameter [1-7/16in.])

2.Plug the TS 55 power cord into the auxiliary outlet on the extractor (if so equipped).

3.Set the power switch on the extractor to “Auto.” (The auxiliary power outlet is active only when the switch is set to Auto.)

16	TS 55 EQ Circular Saw

Image 16

Contents TS 55 EQ Warranty Conditions of 1+2 WarrantyFestool Limited Warranty Liability StatementContents General Safety Rules Specific Safety Rules for Circular Saws ServiceCauses and Prevention of Kickback Respiratory Exposure WarningTechnical Specifications Tool DescriptionSetting up a New Saw Setup and AdjustmentsSingle-Point Entry Adjusting the Guide Rail Gib Cams Trimming the Guide Rail Splinter GuardReplacing and Adjusting the Riving Knife Trimming the Outrigger Splinter GuardChanging the Sawblade Sawblade Checks and WarningsRemoving the Sawblade Replacing the SawbladeSetting the Blade Perpendicular to the Sole Plate Adjustment ProcedureAdjusting the 45º Bevel Stop Matching the TS 55 to an Existing Guide RailSetting the Motor Speed Setting the Blade DepthOperation Using the Outrigger Splinter Guard Turning On the SawSetting the Bevel Angle Using the Guide StopUsing Dust Extraction Straight-Lining Rough Lumber ApplicationsTips for Successful Straight-Lining Crosscutting and Trimming Tips for Successful CrosscuttingGeneral Procedure Plunge CuttingCutting Non-Wood Materials Soft PlasticsBrittle Plastics Thin AluminumAccessories SawbladesGuide Rail Accessory Kit Guide RailsDust Cover Rip Fence Parallel GuideParts of the Systainer Systainer System ContainerStacking Systainers Troubleshooting Symptom Possible CausesMaintenance Routine MaintenanceKeep the Saw Clean Adjust and Inspect the SawReplacing the Guide Rail Gib Cams Replacing the Guide Rail Splinter GuardProcedure Changing the Motor Brushes