
Troubleshooting
Symptom | Possible Causes |
Motor does not start | 1. Check that the cord is properly plugged into an outlet. |
| 2. Make sure the outlet has power. Check the circuit breaker or try another outlet. |
| 3. If used with a Festool dust extractor, make sure the selector switch is pointing to |
| "Auto". The auxiliary outlet on the dust extractor has power only when the |
| selector is at Auto. |
| 4. Inspect the power cord (including extension cords) for damage or missing |
| prongs. |
| 5. The motor brushes may have worn and need replacement. |
|
|
The guide rail gib cams won’t stay | ► The cams may be worn and have a |
tight | ► The friction washers may be worn or missing. |
The saw makes a "Growling" sound | This sound is normal and expected. It is the result of the gears in the saw's heavy |
when it is first turned on or idling. | duty drivetrain reacting to the speed control of the motor. |
| The electronic controller in the motor controls the motor speed by turning it On |
| and Off very rapidly. This form of speed control is called |
| Modulation" (PWM), and is common in most power tools with a variable speed |
| control. When there is no load on the sawblade, the pulsations of the motor cause |
| the gears to rapidly engage and disengage (called backlash), and this is the sound |
| you are hearing. |
The saw makes wavy cuts | ► Make sure the guide rail gib cams are properly adjusted. |
| ► Inspect the blade for damage. |
| ► Make sure the sole plate is not rocking on the guide rail. |
| ► Keep the blade depth consistent during the cut; don’t raise and lower the blade. |
| ► Forcing an |
Saw cuts are burning | ► Make sure to use the correct blade for the material. |
| ► Make sure the blade is sharp. |
| ► Make sure the blade is installed correctly (not turning backward). |
| ► Reduce the motor speed. |
| ► If possible, increase the blade depth. |
Excessive chipping on the lower | ► Make sure to use the correct blade for the type of material and type of cut. |
edge of the cut | ► A very shallow blade depth can cause chipping on the underside if the teeth are |
| barely protruding below the surface. Increase the blade depth. |
Excessive chipping on the top edge | ► Make sure to use the correct blade for the type of material and type of cut. |
of the cut | ► Inspect the splinter guard. Make sure it is flush with the cut line for its entire |
| length. |
| ► Materials prone to splintering may splinter more if the blade is set too deep. |
24 | TS 55 EQ Circular Saw |