Panasonic KX-HNS101 manual Part names and functions, About the LED indicator, Setup overview

Page 8

Setup

Part names and functions

n Sensor unit

AB C

n Magnet unit

D

Sensor unit cover

MN

Used to confirm the status of the sensor or register the sensor to the hub.

LED indicator

Magnet unit cover

About the LED indicator

You can press MN and check the LED indicator to confirm the sensor’s status.

Indicator		Status
Green, lit		Window/door is closed

Red, lit		Window/door is open

Indicator		Status
Red,		Sensor is out of range
blinking		of the hub

Green,		Registration mode
blinking		(You pressed and held
		M	N)

Off		No battery power

Note:

RThe LED indicator does not indicate sensor status if the sensor has not been registered (page 9).

Setup overview

1Initial setup

Make sure you can access the system using your mobile device. For details, refer to the System Setup Guide included with your hub.

2Insert the battery

The window/door sensor is battery powered.

3Registration

Required only if the window/door sensor was purchased separately (i.e., not as part of a bundle).

4Confirm the installation area Read the information in this document to confirm that the desired installation area is suitable to proper operation.

5Temporary placement Temporarily place the window/ door sensor in the desired location and confirm that it operates properly (page 11).

6Installation

Install the window/door sensor on the same position where proper

8For assistance, please visit www.panasonic.com/support

Image 8

Contents Installation Guide Thank you for purchasing a Panasonic productIntroduction Other information Accessory informationSupplied accessories For your safety About this systemImportant safety instructions For best performanceGeneral information Hub location/avoiding noiseRoutine care Other informationEnvironment Important Information Part names and functions About the LED indicatorSetup overview Inserting the battery Using registration buttonsUsing the app Registering the window/door sensorWireless communication range Changing the sensor typeConfirming proper operation Temporary placementIndicator Incorrect Example 1 Installed on the left of the windowCorrect Example 2 Installed on the right of the window Installation Securing with screwsSensor unit Removing when secured with double-sided tape Securing with double-sided tapeAccessing the User’s Guide Testing the window/ door sensorFeatures available when using the Home Network app Specifications FCC and other information FCC RF Exposure WarningFCC ID can be found inside the sensor unit Customer services For hearing or speech impaired TTY users, TTYOr, contact us via the web at Or, send your request by E-mail toWarranty For United States and Puerto Rico Limited Warranty CoverageLimited Warranty Limits And Exclusions When you ship the productIf your product is not working properly For your future reference