Panasonic KX-HNS101 manual Temporary placement, Confirming proper operation, Indicator

Page 11

Setup

Temporary placement

Before installing the window/door sensor, temporarily place it in the desired

location and confirm that it operates properly by pressing MN.

Important:

RAttach the sensor unit to the outer frame of the window or door, and the magnet unit to the inner frame.

RAttach both units so that the “” marks point toward each other and are within 25.4 mm (1 inch) of each other.

RThe window/door sensor will not operate properly if the “” marks are too far apart or are facing the wrong way.

Confirming proper operation

After temporarily placing the window/door sensor in the desired location, press

MN while the window or door is closed. The window/door sensor’s LED indicator lights as follows.

Indicator

Green, lit

Red, lit

Red, blinking

Note:

Status

The installation position is correct.

The “” marks on the sensor unit and the magnet unit are too far from each other. Re-attach the sensor unit and the magnet unit so that they point directly at each other and are no more than 25.4 mm (1 inch) apart.

The sensor unit is out of range of the hub. Refer to the information on page 10.

RDepending on the condition and material of the surface where the sensor unit and magnet unit are installed, the LED indicator may light in red even if the “” marks point directly at each other and are no more than 25.4 mm (1 inch) apart.

For assistance, please visit www.panasonic.com/support

11

Page 10 Page 12
Image 11
Page 10 Page 12
Contents Thank you for purchasing a Panasonic product Installation GuideIntroduction Other information Accessory informationSupplied accessories About this system For your safetyHub location/avoiding noise Important safety instructionsFor best performance General informationRoutine care Other informationEnvironment Important Information Part names and functions About the LED indicatorSetup overview Registering the window/door sensor Inserting the batteryUsing registration buttons Using the appChanging the sensor type Wireless communication rangeConfirming proper operation Temporary placementIndicator Incorrect Example 1 Installed on the left of the windowCorrect Example 2 Installed on the right of the window Securing with screws InstallationSensor unit Securing with double-sided tape Removing when secured with double-sided tapeAccessing the User’s Guide Testing the window/ door sensorFeatures available when using the Home Network app Specifications FCC RF Exposure Warning FCC and other informationFCC ID can be found inside the sensor unit Or, send your request by E-mail to Customer servicesFor hearing or speech impaired TTY users, TTY Or, contact us via the web atLimited Warranty Coverage Warranty For United States and Puerto RicoWhen you ship the product Limited Warranty Limits And ExclusionsFor your future reference If your product is not working properly
Top Page Image Contents