USE OF LUBRICANTS
NEVER USE LIQUID COOLANT WITH YOUR BAND SAW. Damage to the blade guide bearings or rubber tires on the pulleys may result.
With the saw running, apply to wax momentarily to both sides of the blade. Reapply wax intermittently as needed.
WARNING: EXERCISE EXTREME CARE TO PREVENT HANDS 
FROM CONTACTING THE BLADE.
After prolonged cutting, the wax will cling to the pulleys of your BAND SAW. This does not affect the operation of the machine. All that is necessary is to disconnect the machine from the power source and wipe the wax from the pulleys.
ASSEMBLY
TO CHANGE SAW BLADES
CAUTION: DISCONNECT TOOL FROM POWER SOURCE.
TO REMOVE BLADE – Turn handle (A), Fig. 3, clockwise to release tension on the saw blade. Remove the blade, first from the pulleys and then from the blade guide.
Before installing a blade, clean chips and wax, which may have accumulated on blade guides and pulley tires. TO INSTALL BLADE insert blade in blade guides and then position on pulleys. MAKE SURE TEETH ON LEFT SIDE OF MACHINE POINT TOWARD THE REAR OF THE MACHINE. See Fig. 4 and 5.
Turn handle (A), Fig. 3, counterclockwise as far as it will go. This places tension on saw blade.
Start and stop saw two or three times to seat blade on pulleys.
A
Fig. 3
➡
DIRECTION OF BLADE TRAVEL
ON LEFT SIDE OF MACHINE POSITION OF TEETH ON
LEFT SIDE OF MACHINE
Fig. 4
8