11.IMPORTANT: Make certain the spindle taper (Q) Fig. 15, and tapered hole in chuck (R) are clean and free of any grease, lacquer or rust preventive coatings. NOTE: Household oven cleaner can effectively remove any sub- stance from the spindle and chuck; however, carefully follow the manufacturer's safety rules concerning its use.
12.IMPORTANT: OPEN THE CHUCK JAWS AS WIDE AS POSSIBLE MAKING SURE THE CHUCK JAWS ARE UP INSIDE CHUCK.
13.Holding chuck on taper of spindle, tap with a soft tip hammer (T) or a block of wood and hammer to set chuck, as shown in Fig. 16.
To avoid damage to the chuck, NEVER drive the chuck onto the spindle with a metal hammer.
FOR MODEL 17-925 ONLY
14.Thread the three pinion shaft handles (U) into the three holes located in the pinion shaft hub (V), as shown in Fig. 17.
FOR MODEL 17-990X ONLY
14. Remove screw (A) Fig. 17A, and flat washer (B).
Q
R
Fig. 15
S
T
Fig. 16
V
U
Fig. 17
B
A
Fig. 17A
10