Porter-Cable 17-990X, 17-925 instruction manual

Page 11

Place handle (A) Fig. 17B on pinion shaft (C). Make sure key slot (D) in handle is aligned with the key (E) on the pinion shaft

Replace flat washer (C) Fig. 17C and thread screw (B) into pinion shaft and tighten securely.

15.Thread the two speed changing levers (W) Fig. 18, into the speed changing hub as shown.

16.Thread the speed range changing lever (X) Fig. 19, into hub as shown.

A

D

C

E

Fig. 17B

C

B

Fig. 17C

W

W

Fig. 18

X

Fig. 19

11

Image 11

Contents 16½ Variable Speed Drill Press Safety Guidelines Definitions Refer to them often Use them to instruct others Additional Safety Rules for Drill PressesPower Connections Extension Cords Unpacking and Cleaning11A 11B12 Drill Press PartsAssembly With 3mm Wrench Supplied Page For Model 17-990X only For Model 17-925 onlyPage Mounting Drill Press to a Plywood Base Fastening Drill Press Base to a Supporting SurfacePermanent Mounting Starting and Stopping Drill Press Operating Controls and AdjustmentsLocking Switch OFF Position Table AdjustmentsDrilling Holes to Depth Variable Speed ControlSpeed Range Control Adjusting Spindle Return Spring Quill AdjustmentsCorrect Drilling Speeds Installing and Removing Drill BitsOperations Drilling Metal Boring in WoodLubrication MaintenancePARTS, Service or Warranty Assistance AccessoriesCanadian PORTER-CABLE Delta Service Centers