Porter-Cable 17-990X, 17-925 instruction manual Assembly

Page 7

ASSEMBLY

FOR YOUR OWN SAFETY, DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTIL THE MACHINE IS COMPLETELY ASSEMBLED AND YOU READ AND UNDERSTAND THE ENTIRE INSTRUCTION MANUAL.

1.Assemble the column (A) Fig. 3, to the base (B) using the four M10x40mm hex head screws (C), three of which are shown. Loosen set screw (D) with 3mm wrench supplied, and remove ring (E) and raising rack (F).

2.Insert small end of worm gear (G) Fig. 4 and Fig. 5, through hole (H), from the inside of the table bracket. Make certain that the worm gear engages the internal gear in the table bracket.

G

H

Fig. 4

3.Insert raising rack (F) Fig. 6, which was removed in STEP 1, into groove in table bracket (I) making sure teeth of internal gear, located inside table bracket, are engaged with teeth of raising rack (F).

ED

F

A

B

C

Fig. 3

H

G

Fig. 5

I F

Fig. 6

7

Image 7

Contents 16½ Variable Speed Drill Press Safety Guidelines Definitions Refer to them often Use them to instruct others Additional Safety Rules for Drill PressesPower Connections Extension Cords Unpacking and Cleaning11A 11B12 Drill Press PartsAssembly With 3mm Wrench Supplied Page For Model 17-990X only For Model 17-925 onlyPage Permanent Mounting Fastening Drill Press Base to a Supporting SurfaceMounting Drill Press to a Plywood Base Starting and Stopping Drill Press Operating Controls and AdjustmentsLocking Switch OFF Position Table AdjustmentsSpeed Range Control Variable Speed ControlDrilling Holes to Depth Adjusting Spindle Return Spring Quill AdjustmentsOperations Installing and Removing Drill BitsCorrect Drilling Speeds Drilling Metal Boring in WoodLubrication MaintenancePARTS, Service or Warranty Assistance AccessoriesCanadian PORTER-CABLE Delta Service Centers