Porter-Cable (Model TS220LS) instruction manual Attach the dado head set D , to the saw arbor

Page 25

2. Attach the dado head set (D) Fig. 57, to the saw arbor.

NOTE: THE OUTSIDE ARBOR FLANGE CAN NOT BE USED WITH THE DADO HEAD SET, TIGHTEN THE ARBOR NUT AGAINST THE DADO HEAD SET BODY. DO NOT LOSE THE OUTSIDE ARBOR FLANGE. IT WILL BE NEEDED WHEN REATTACHING A BLADE TO THE ARBOR.

THE ACCESSORY DADO HEAD SET TABLE INSERT (E) FIG. 57, MUST BE USED IN PLACE OF THE STANDARD TABLE INSERT.

THE BLADE GUARD AND SPLITTER ASSEMBLY CANNOT BE USED WHEN DADOING AND MUST BE REMOVED OR SWUNG TO THE REAR OF THE SAW. AUXILIARY JIGS, FIXTURES, PUSH STICKS AND FEATHER BOARDS CAN AND SHOULD BE USED.

3.Fig. 58, shows a typical dado operation using the miter gage as a guide.

NEVER USE THE DADO HEAD IN A BEVEL POSITION.

ALWAYS INSTALL BLADE GUARD AFTER OPERATION IS COMPLETED.

E

D

Fig. 57

Fig. 58

25

Image 25

Contents Table Saw General Safety Rules Safety Guidelines DefinitionsImportant Safety Instructions Stay ALERT, Watch What YOU are DOING, Failure to Follow These Rules MAY Result in Serious InjuryFailure to Follow These Rules MAY Result in Serious Injury Additional Safety Rules for Table SawsMotor Specifications Power ConnectionsVolt Single Phase Operation Grounding InstructionsMinimum Gauge Extension Cord Extension CordsAssembly Unpacking and CleaningFunctional Description ForewordPage Stand Parts SAW to Stand Stand AssemblyAssembling Blade Raising and Lowering Handwheel Blade Guard Splitter Assembly Page Guide Rail to SAW Extension WingMiter Gage RIP FenceMiter Gage Holder Disconnect Machine from Power SourceOutfeed Support Locking Switch OFF Position Operating Controls and AdjustmentsStarting and Stopping SAW Overload ProtectionTo Adjust Positive Stop AT 90 Degrees Adjusting 90 and 45 Degree Positive StopsTo Adjust Positive Stop AT 45 Degrees Blade Tilting ControlMiter Gage Operation and Adjustments RIP Fence Operation AdjustmentsC B Changing the Blade Adjusting Blade Parallel to Miter Gage SlotsACB Common Sawing Operations Never USE the Fence AS a CUT-OFF Gage When CROSS-CUTTINGCROSS-CUTTING Constructing a Push Stick RippingAccessory Dado Cutterhead Using Auxiliary Woodfacing on RIP FenceAttach the dado head set D , to the saw arbor Constructing a Featherboard Constructing a Push Stick PushstickAccessories Canadian PORTER-CABLE Delta Service Centers