Porter-Cable (Model TS220LS) instruction manual Stand Parts

Page 9

58 55

49

56 57

51

53	54

5250 Fig. 4

STAND PARTS

49 - Leg (4)

50 - 3/8” Flat Washer for Mounting Saw to Stand & for Assembling Stand (24) 51 - Foot (4)

52 - M8x1.25 Hex Nut for Mounting Saw to Stand & for Assembling Stand (20) 53 - M8x1.25x40mm Hex Screw for Mounting Saw to Stand (4)

54 - M8x1.25x20mm Carriage Bolts for Assembling Stand (16)

55 - 18-1/2” Top Front and Rear Brackets (2)

56 - 17” Top Side Brackets (2)

57 - 22” Bottom Front and Rear Brackets (2)

58 - 20-3/8” Bottom Side Brackets (2)

FOR YOUR OWN SAFETY, DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTIL THE MACHINE IS COMPLETELY ASSEMBLED. DO NOT OPERATE THIS MACHINE UNTIL YOU READ AND UNDERSTAND THE ENTIRE INSTRUCTION MANUAL

9

Image 9

Contents Table Saw Safety Guidelines Definitions General Safety RulesImportant Safety Instructions Stay ALERT, Watch What YOU are DOING, Failure to Follow These Rules MAY Result in Serious InjuryFailure to Follow These Rules MAY Result in Serious Injury Additional Safety Rules for Table SawsMotor Specifications Power ConnectionsVolt Single Phase Operation Grounding InstructionsMinimum Gauge Extension Cord Extension CordsAssembly Unpacking and CleaningFunctional Description ForewordPage Stand Parts SAW to Stand Stand AssemblyAssembling Blade Raising and Lowering Handwheel Blade Guard Splitter Assembly Page Guide Rail to SAW Extension WingMiter Gage RIP FenceMiter Gage Holder Disconnect Machine from Power SourceOutfeed Support Locking Switch OFF Position Operating Controls and AdjustmentsStarting and Stopping SAW Overload ProtectionTo Adjust Positive Stop AT 90 Degrees Adjusting 90 and 45 Degree Positive StopsTo Adjust Positive Stop AT 45 Degrees Blade Tilting ControlRIP Fence Operation Adjustments Miter Gage Operation and AdjustmentsC B Adjusting Blade Parallel to Miter Gage Slots Changing the BladeACB Never USE the Fence AS a CUT-OFF Gage When CROSS-CUTTING Common Sawing OperationsCROSS-CUTTING Constructing a Push Stick RippingAccessory Dado Cutterhead Using Auxiliary Woodfacing on RIP FenceAttach the dado head set D , to the saw arbor Constructing a Featherboard Constructing a Push Stick PushstickAccessories Canadian PORTER-CABLE Delta Service Centers