Porter-Cable 3802 instruction manual Instruction

Page 1

		ESPAÑOL: PÁGINA 21
		FRANÇAISE : PAGE 41
Instruction	12" Compound
Manual		Miter Saw

To learn more about Porter-Cable

visit our website at:

http://www.porter-cable.com

MODEL 3802

IMPORTANT

Please make certain that the person who is to use this equipment carefully reads and understands these instructions before starting operations.

The Model and Serial No. plate is located on the main housing of the tool. Record these numbers in the spaces below and retain for future reference.

Model No. _____________________________________

Type __________________________________________

Serial No.______________________________________

Part No. 900988 - 11-30-00

Image 1

Contents Instruction Read and Follow ALL Instructions Important Safety InstructionsAttempt to Repair Power Cord Additional Safety Rules for Compound Miter SawsPower Connections Replacement PartsMotor Extension Cord SelectionAssembly Moving Cuttinghead to the UP Position Attaching Extension Table and Fence Slide Moving Table to the 0 Degree CUT-OFF PositionSliding FIT Between Movable Table and Base Page Fastening Machine to Supporting Surface Attaching Dust BAGStarting and Stopping Machine Adjusting Sliding FIT Between Movable Table and Base Locking Switch in the OFF PositionRotating Table for Miter Cutting Tightened if NecessaryTable Hazard Area Adjusting Fence 90 Degrees to BladeTilting Cuttinghead for Bevel Cutting Attaching Optional Work ClampAdjusting Chip Deflector Adjusting Sliding FenceDisconnect the SAW from the Power Source Adjusting Sliding FIT Between Trunnion and Bevel Bracket Adjusting 0 and 45 Degree Bevel Positive StopsDisconnect the SAW from the Power SourceAdjusting Sliding FIT Between Cuttinghead ARM and Trunnion Adjusting the Tension of Cuttinghead Return SpringAdjusting Downward Travel of SAW Blade Adjusting Blade GuardAuxiliary Wood Fence Typical Operations and Helpful HintsCutting Aluminum While the Machine is RunningConstructing Work Support Extensions Cutting Bowed MaterialCutting Crown Moulding Changing the Blade Disconnect Machine from the Power SourceKeep Tool Clean Brush Inspection and ReplacementService and Repairs Failure to StartPage Delta Service Centers

Instruction

Manual

Miter Saw