Porter-Cable 3802 instruction manual Moving Table to the 0 Degree CUT-OFF Position

MOVING TABLE TO THE 0 DEGREE CUT-OFF POSITION

1.Rotate locking knob (A) Fig. 6, counter-clockwise as far as it will go to unlock. Depress lever (B) and rotate table (C) to the 0 degree straight cut-off position, release lever (B) and tighten locking knob (A).

2.Fig. 7, illustrates the table (C) in the 0 degree straight cut-off position.

3.For proper operation and adjustment of the table, refer to sections, “ROTATING TABLE FOR MITER CUTTING”, “ADJUSTING CLAMPING ACTION OF TABLE LOCKING MECHANISM” and “ADJUSTING

SLIDING FIT BETWEEN MOVABLE TABLE AND BASE.”

ATTACHING EXTENSION TABLE AND FENCE SLIDE

C

B

A

Fig. 6

B

A

Fig. 7A

C

Fig. 7

B

C

Fig. 7B

1.Attach flat washers to the two 3/4” screw assemblies (A) Fig. 7A, and thread into the threaded holes on left side of the saw.

NOTE: Turn the screws only a few threads into the holes at this time.

2.Attach the table extension (B) Figs. 7A and 7B, to left side of saw table, making sure groove of table extension (B) is inside flat washers (C) as shown in Fig. 7B.

6