TO ASSEMBLE RIP GUIDE
A rip guide (A), Fig. 13, is available as an accessory. Install rip guide as follows:
1.CAUTION: DISCONNECT TOOL FROM POWER SOURCE.
2.Insert rip guide through slot in left side of base, over stud and through slot in right side of base.
A 
Fig. 13
3.Install knob and washer on stud and adjust rip guide for desired width of cut, taking into consideration the set of the blade teeth.
4.Tighten knob securely.
CAUTION: To avoid damage to workpiece and possible personal injury, the rip guide should always extend through both slots in base.
HOW TO USE THE SAW
For protection of the operator, effective control of this powerful saw requires
WARNING: It is important to support the work properly and to hold the saw firmly to prevent loss of control which could cause personal injury. Fig. 14 illustrates proper hand support of the saw.
Clamp work on a rigid support such as a bench or saw horses. See Fig. 14. Mark the line of cut on the work. Be sure
CAUTION: Keep the cord away from the cutting area, so it does not get hung up in the work being cut. See Fig. 14.
A
A
Fig. 14
12