FUNCTIONAL DESCRIPTION
FOREWORD
Your
SELECTING A BLADE
A combination blade is furnished with your saw and is an excellent blade for all general ripping and crosscutting operations. A fine tooth blade is recom- mended for cutting plywood. A diamond blade is available for dry cutting concrete, brick, stone, etc.
REMOVING THE BLADE
1.CAUTION: DISCONNECT TOOL FROM POWER SOURCE.
2.Push in blade lock (A) Fig. 1 and rotate blade by hand until lock engages blade arbor.
3.While holding blade lock
engaged, use wrench provided |
|
| |||
(B), Fig. 1, | and | loosen blade |
| A | |
| |||||
retaining | bolt | by | rotating |
|
|
clockwise. | NOTE: | Blade |
|
| |
retaining bolt has a left hand |
|
| |||
thread. |
|
|
|
|
|
4.Remove blade retaining bolt,
release blade lock and | remove | B |
|
|
| ||||
outer blade flange. |
|
|
|
|
5. Retract telescoping | guard |
|
|
|
|
| Fig. 1 | ||
and remove blade. |
|
|
| |
|
|
|
|
INSTALLING THE BLADE
1.CAUTION: DISCONNECT TOOL FROM POWER SOURCE.
2.Remove any sawdust that may have accumulated within guards, around arbor, and telescoping guard spring. Check the telescoping guard to insure it is in working order.
3.Clean inner blade flange and retract telescoping guard and place sharp blade on arbor making sure teeth point up at front of saw as shown in Fig. 2.
CAUTION: AVOID CONTACT WITH BLADE TEETH TO PREVENT PERSONAL INJURY.
4.Place outer blade flange on arbor with flange towards blade and flats mating with those on arbor.
5.Replace blade retaining bolt and finger tighten by turning
6.Push in blade lock and rotate blade arbor by hand until lock engages arbor. Tighten blade retaining bolt with wrench provided just enough to prevent blade slippage during normal cutting and
release blade lock. | Fig. 2 |
|
7