4. Press depth adjusting |
|
locking lever down firmly locking | B |
saw in selected position. |
|
TO ADJUST FOR BEVEL
CUTS
1. | CAUTION: DISCONNECT |
|
|
|
| |
TOOL FROM POWER SOURCE. |
|
|
|
| ||
2. | Lift up bevel adjustment |
|
|
|
| |
locking lever (A), Fig. 5. | A |
| C | |||
3. | Tilt saw base until desired |
|
|
| ||
|
|
|
| |||
graduation line on the bevel |
|
|
|
| ||
| Fig. 5 | |||||
segment (B), Fig. 5, lines up with |
| |||||
indicating mark (C), Fig. 5 on |
|
|
|
|
| |
|
|
|
|
| ||
bracket. |
|
| B | |||
4. | Return bevel adjustment |
|
| |||
| A |
| ||||
locking lever to locked position |
|
| ||||
|
|
|
| |||
and press down firmly. |
|
|
|
| ||
90° and 45° BEVEL POSITIVE STOPS
This saw is equipped with adjustable positive stops for both 90° (A), Fig. 6, and 45°
bevel (B), Fig. 6, cuts. These have been set at the factory and it is recommended they be checked occasionally to assure accuracy.
TO ADJUST 90° POSITIVE STOP
1.CAUTION: DISCONNECT TOOL FROM POWER SOURCE.
2.Loosen bevel adjustment locking lever (A), Fig. 5, and position base for 90° cuts being sure that the top of the base is in contact with the bottom of stop screw (A), Fig. 6, and tighten locking lever.
3.Turn saw upside down, retract telescoping guard and check squareness of blade as shown in Fig. 7.
4.If adjustment is necessary loosen bevel adjustment locking lever, keeping top of base in contact with stop screw, turn stop screw until squareness is obtained.
Fig. 7 | Fig. 8 |
TO ADJUST 45° BEVEL POSITIVE STOP
1.CAUTION: DISCONNECT TOOL FROM POWER SOURCE.
2.Loosen bevel adjustment locking lever and tilt base until top of stop screw (B), Fig. 6, contacts extension on bevel segment and tighten locking lever.
9