3.With the aid of a second person, lift the saw body out of the shipping container and place on top of the stand. Be sure front of saw (with Powermatic logo) faces curved stand front.
WARNING
Use caution when lifting and stabilize until firmly attached to the
stand! Failure to comply may cause
serious injury!
4.Line up holes in the saw body with holes in the top of the stand. Fasten saw body to the stand with four M8 x 40 hex cap screws, eight M8 washers, four M8 lock washers, and four M8 hex nuts (Fig. 2)
5.Push motor cord and strain relief plate through the opening in the side of the stand. Fasten the strain relief plate to the stand with two M5 x 12 pan head screws as shown in Fig. 3.
6.Connect the plugs of the switch cord and motor cord (Fig. 3). Do not connect machine to power source during assembly.
7.Check the alignment of the pulleys by placing a straight edge against the flat sides of the motor and wheel pulleys (Fig. 3a). If the pulleys lie in a straight plane (Fig. 3b) they are aligned. If they do not lie in a straight plane, loosen the set screw on one of the pulleys and shift the pulley in or out until both pulleys lie in a straight plane. Tighten set screws.
8.Open the lower door, and place the
around the motor pulley and the wheel pulley (see Fig. 3a).Saw body is heavy!
12