Powermatic PWBS14 operating instructions

9.Loosen the nuts on the four motor mounting bolts (Fig. 4), and tension the v-belt by pushing down on the motor. Tighten the four motor mounting nuts.

The v-belt is properly tensioned when finger pressure between the two pulleys causes approximately 1/2" deflection (Fig. 4a).

10.Screw the two small knobs (Fig. 5) into the threaded holes in the saw body. Slide the pulley cover down over the knobs, and tighten the knobs.

11.Attach trunnion support to saw body with two M8 x 30 hex cap screws and two M8 lock washers (A, Fig. 6).

12.Thread nut (B, Fig. 6) onto table stop bolt (C, Fig. 6) and attach to trunnion support as shown.

13