20.The air hose, which is already connected to the saw body, should be inserted through the hole in the stand and connected to the nozzle of the air regulator (Fig. 10). Use a lighter or match to briefly heat the end of the hose so that it will slip over the nozzle. As it cools, it will form a tight seal over the nozzle.
21.Connect the top end of the air hose to the blade guide assembly with the pan head screw through the cord clamp (Fig. 10a). Again, use a lighter or match to heat the end of the hose before pushing the nozzle into it. NOTE: Push the wide end of the nozzle into the hose; the tapered end will be pointed down toward the table as shown.
22.Mount the work lamp to the saw body with two M5 x 8 pan head screws (Fig. 11). The work lamp uses a medium base light bulb (not provided) which should be 60 watts or less.
15