Multiquip HS62A manual Belt Changing Procedure, Knob, Cover Guard, Remove the V-belt

HS62A CUT-OFF SAW — MAINTENANCE

V-Belt Changing Procedure

N

Remove the 2 hex nuts and hex screw and washer to

gain access to the V-belt on the clutch side. Remove V-belt

cover .

Figure 14. Belt Guard Cover Removal

Remove the 2 hex nuts		and hex screw and guard adjustment
knob	to gain access to theV-belt on the spindle side. Remove
the Cover Guard		.

Figure 15. Re-Installing Cover Guard

Using the provided wrench, loosen the three nuts to reduce

the tension on the V-belt, then turn the V-beltTensioning Cam

until the V-belt is completely slacked.

Figure 16. V-Belt Tensioning

Remove the V-belt from the clutch and spindle pulleys.

Install the new V-belt around both pulleys. It is essential that the drive V-belt is properly positioned around both the clutch and spindle pulleys.

Figure 17. Drive V-Belt

HS62A CUT-OFF SAW — OPERATION & PARTS MANUAL — REV. #0 (10/20/06) — PAGE 21