STOW CUTTER 1 SAW — BLADE PLACEMENT
BLADE PLACEMENT
WARNING
Failure to thoroughly inspect the diamond blade for operational safety could result in damage to the blades or the saw and may cause injury to the user or others in the operating area.
1.Blade Guard - Pivot the blade guard front cover all the way back. The guard
tension spring will keep the front cover in position.
2.Blade Hex Nut - Unscrew the blade shaft nut (right side loosens clockwise and tightens
3.Outside Blade Flange (Collar) - Ensure that the outside blade flange is placed flush against the diamond blade. The inside surface of the flange must be free of debris and permit a tight closure on the surface of the blade core.
4.Diamond Blade - Ensure that the proper diamond blade has been selected for the job. Pay close attention to the directional arrows on the blade. The blade's operating directional arrows must point in a
5.Inner Flange (Collar) - This flange is fixed upon the blade shaft. The inside surface of the flange must be free of debris and permit a tight closure on the surface of the blade.
Blade Speed
A diamond blade’s performance is directly connected to specific peripheral (rim) speeds.
The following shaft rotational speeds have been factory set to ensure optimum blade performance.
zCUTTER 1-
NOTE | The following steps should be | |
accomplished before using the saw | ||
| ||
| on any cutting surface. |
WARNING
Dropping or forcing the blade onto the cutting surface can severely
damage the diamond blade and may cause serious damage to the saw and bodily harm.
Blade Removal and Replacement
1.Set the engine ON/OFF switch to the "OFF" position. (Unplug electric models.)
2.Place the saw on a stable level working surface.
3.Ensure the blade is raised and the raise/lower crank is locked into position.
When removing or installing a
NOTE diamond blade, please note that the blade retaining nuts are left and right- hand threaded.
5.Lift up the blade guard cover to gain access to the blade.
6.Use the provided blade nut and blade shaft locking wrenches to remove and install the blade.
■While holding the blade shaft with the locking wrench, remove the blade hex nut (clockwise direction) and outer blade flange.
■Remove the old blade and install a new blade in the same rotational direction as marked on the old blade.
■Reinstall the outer blade flange and hex nut. Tighten the nut firmly
OVERTIGHTEN.
Cutting Depth Adjustment
The saw is equipped with a Raise/Lower Assembly that is supported by the following components.
■Raise/Lower Acme Screw
■Jack Arm
■Blade Guard
■Adjusting Handle Crank