Multiquip CD613H18 (Honda GX390 Gasoline Engine) manual Stow Cutter 1 SAW Controls & Components

STOW CUTTER 1 SAW — CONTROLS & COMPONENTS

CONTROLS & COMPONENTS

Figure 3 shows the location of the basic controls or components for the STOW CUTTER 1 SAW. Listed below is a brief explanation of each control or component. (Gasoline-powered unit shown)

1.Hand Grips/Handlebar – When operating the saw, place both hands on each grip to maneuver the saw. Replace hand grips when they become worn or damaged.

2.Handle Lock – Lock blade depth to desired position.

3.Garden Hose Connecter – Connect to water source to provide blade cooling while cutting concrete or asphalt.

4.Air Filter – Prevents dirt and debris from entering the engine air intake. Check filter periodically and keep cleaned or replace when necessary.

5.Recoil Starter Handle – Pull to engage and start the engine.

6.Recoil Starter Assembly – Engages the engine when the handle is pulled and rewinds the starter rope when the handle is released.

7.Wheels/Carriage Assembly – Heavy-duty polyurethane wheels with permanently sealed ball bearings.

8.Cutting Blade – Use appropriate type blades for cutting concrete or asphalt.

9.Blade Guard – Covers saw blade and flips up to allow blade to be changed.

10.BeltTension Adjuster – Adjusts belt tension.

11.Front Pointer – Front pointer wheel assists in straight tracking.

12.Front Pointer Arm – Stows up for storage and pivots down for use.

13.Cutting Depth Adjuster – turn operating crank clockwise or counter-clockwise to adjust the cutting depth up or down.

14.FuelTank – Use unleaded gasoline. Do not overfill.

15.Blade Coolant System – Provides cooling water to blade during cutting operations.

16.V-Belt Cover – Remove this cover to gain access to the V- belt. NEVER operate the saw with this cover removed.

17.Arbor Shaft Grease Zerks – Conveniently located for lubrication.

18.On/Off Switch – Turn to the "ON" position to allow engine to be started and turn to the "OFF" position to shut the engine off.

Figure 3. Cutter 1

STOW CUTTER 1 SAW — OPERATION & PARTS MANUAL — REV. #6 (06/06/08) — PAGE 13