Vector VEC118S owner manual Operation

Page 4

3.OPERATION

The trigger switch is squeezed to turn on the spotlight. This provides momentary operation. The trigger switch may be locked in the ON position to provide continuous light without continuously squeezing the trigger switch. To lock the trigger switch ON, move the trigger lock to the up position. After use, move the trigger lock down (OFF) and release the trigger switch. Store the spotlight with the trigger switch OFF and the trigger lock ON. ON/OFF operation of the area light is controlled by the area light pushbutton. This long lasting light can continuously operate up to 25 hours on a full battery charge.

FIGURE 1 shows locations of the trigger switch, trigger switch lock, area light and the area light's pushbutton switch.

STRAP HANDLE

SNAP LINK LOOP

TRIGGER SWITCH

SNAP LINK LOOP

TRIGGER SWITCH LOCK

AREA LIGHT

DC RECHARGE AND POWER PORT

AREA LIGHT

PUSHBUTTON

AC CHARGING LED

AC RECHARGE PORT

NOTE: This unit is shipped in a partially charged state. Initially charge unit using the AC charger for 5 hours or until green LED turns OFF. Charge after each use.

CAUTION: Do not recharge using AC and DC chargers at the same time.

4

Image 4
Contents Warranty Information Important Safety Instructions During RechargeAdditional Features IntroductionOperation Charging the Vectorlite Using AC Recharge Adapter CHARGING/OPERATING from a DC SourceParts Replacement Periodic MaintenanceSpotlight Bulb Replacement Reflector Assembly Retaining Ring Rubber Bezel Do not MIX Battery Types or NEW and OLD Batteries Replacing the BatteriesBattery Disposal Warnings Safe Battery DisposalSpecifications TWO Year Limited Warranty Program