FIGURE 3A
REFLECTOR ASSEMBLY
RETAINING RING
RUBBER BEZEL
RUBBER”O”OpenRING
PHILLIPS SCREW
GLASS LENS
Closed
Open
HAIRPIN RETAINING
WIRES
FIGURE 3B
Closed
SCREW
10.Insert the replacement bulb into the reflector's flange.
11.Put back and secure the hairpin retaining wires.
12.Connect the white bulb power wire to the red power wire.
13.Tighten the retaining screw on the flange.
14.Place the reflector in position in the body of the spotlight.
15.Replace the rubber "O" ring in the groove around the perimeter of the reflector.
16.Replace glass and retaining ring so that the screw holes are aligned.
17.Secure retaining ring with two Phillips screws.
18.Replace rubber bezel by sliding forward to the front of the spotlight.
19.Operate switch to ensure proper operation of spotlight.
7