5.PERIODIC MAINTENANCE
All batteries lose charge over time, especially when they are warm. AC recharge is recommended every two months, when not in frequent use. Use the AC recharger and charge for the recommended time. If the unit has dirt on it, gently clean the outer surfaces of the spotlight unit with a soft cloth moistened with a mild solution of water and detergent. Periodically inspect the condition of recharge adapters, connectors, and wires. Replace any components that may have become worn or broken.
6.PARTS REPLACEMENT
Several parts are replaceable by users. The quartz halogen bulb and two sealed lead acid batteries are proprietary and are available through Vector Manufacturing. A substitute 12 volt H3 75 watt bulb may be used instead of a Vector bulb. These can also be purchased from popular automotive parts suppli- ers nationwide. A "festoon" type automotive 12 volt 3.6 watt bulb is replaceable in the area light. Contact Vector Manufacturing's Technical Support Department for replacement parts and any additional information that you may need. They may be reached at (954)
SPOTLIGHT BULB REPLACEMENT
To replace the H3 type 12 volt bulb, you will need a small Phillips type screwdriver and a replacement bulb (Vector Part VEC190). Bulb life can be shortened by installing a bulb with dirt or fingerprints on it. The bulb can be wiped clean with a cloth moistened with alcohol. During bulb installation, avoid touching the glass part of the bulb. See Figures 3A and 3B for details.
1.Disconnect the unit from any charging adapters.
2.Pull the rubber bezel towards the front of the spotlight to reveal two small Phillips screws in the wide retaining ring. The screws are on opposite sides of the ring.
3.Using the screwdriver, remove
4.Lift off the retaining ring, glass lens and rubber "O" ring and set them aside.
5.Carefully remove the reflector and bulb assembly.
6.Disconnect the bulb wire from the red power wire and set the burned out bulb aside.
7.Unsnap the hairpin retaining wires from the reflector's flange (Figure 3B)
8.Using the screwdriver, loosen the retaining screw to remove the bulb from the reflector (no need to completely remove this screw).
9.Lift out the bulb and the attached wire.
6