Vector VEC118S owner manual Safe Battery Disposal, Battery Disposal Warnings, Specifications

Page 9

WARNINGS: DO NOT ALLOW BARE WIRES OR CONNECTORS TO CON- TACT EACH OTHER DANGEROUS SPARKING CAN OCCUR - NOTE WHICH WIRES ARE ON THE BATTERY TERMINALS

6.Note position of battery. Note which wire is on which terminal.

7.Disconnect the wires from the battery and set the battery aside.

8.Connect the replacement battery, making sure the correct wires are on the new battery terminals. Make sure POS (+) is red and NEG (-) is black.

CAUTION: Incorrectly connected wires will not allow the spotlight to operate or recharge. Incorrect battery polarity will damage the circuits inside the spotlight. Double check battery polarity before reassembly!

9.Replace battery compartment end cap. Make sure wires are not crushed.

10.Replace four Phillips screws in battery compartment cover. Do not over-tighten.

The lower battery pack can be replaced by following the upper battery replacement procedure except there are only two Phillips screws to be removed.

After the lower battery is replaced and the lower end cap secured, recharge for 10-12 hours using the AC recharge adapter before using the spotlight.

SAFE BATTERY DISPOSAL

Contains maintenance-free, sealed, non-spillable, lead acid batteries, which must be disposed of properly. Recycling is required, contact your local authority for information. Failure to comply with local, state and federal regulations can result in fines, or imprisonment.

BATTERY DISPOSAL WARNINGS:

Do not dispose of a battery in fire as this may result in an explosion.

Before disposing of the battery, protect exposed terminals with heavy-duty electrical tape to prevent shorting (shorting can result in injury or fire).

Do not expose batteries to fire or intense heat as they may explode.

•For more information on recycling these batteries, call toll-free 877-288-7722.

7.SPECIFICATIONS

Spotlight Bulb . . . . . . . . . . . . . . . . 12 volt, H3 series Vector Part No. VEC190 Battery . . . . . . . . . . . . . . . . . . . . . . . Two maintenance free, sealed lead acid, 6 volt, 4.5 Amp Hour Vector Part No. VEC191 Weight . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6.5 lbs (3.0 Kg)

Length

8.63 in. (21.9 cm)

Width

4.25 in. (10.8 cm)

Height

12.5 in. (31.75 cm)

AC Recharge . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12V DC at 500 mA

9

Image 9
Contents Warranty Information During Recharge Important Safety InstructionsIntroduction Additional FeaturesOperation CHARGING/OPERATING from a DC Source Charging the Vectorlite Using AC Recharge AdapterPeriodic Maintenance Parts ReplacementSpotlight Bulb Replacement Reflector Assembly Retaining Ring Rubber Bezel Replacing the Batteries Do not MIX Battery Types or NEW and OLD BatteriesSafe Battery Disposal Battery Disposal WarningsSpecifications TWO Year Limited Warranty Program