
ASSEMBLY
SWITCH |
|
|
|
The switch is located on the front of the grinder near the bottom. To turn the tool ON depress | |||
the rocker switch at the top near the word ON. To turn the tool OFF depress the bottom por- | |||
tion of the rocker switch near the word OFF. |
|
|
|
INSTALLING TOOL RESTS |
|
|
|
Turn off and unplug the bench grinder. |
|
|
|
Remove the tool rests from the top portion of the |
|
|
|
carton liner and install them to the wheel guards as shown | Short |
|
|
in the figure. Use the bolts and washers from the plastic bag |
|
| |
to secure them in place as shown in Figure 1. | bolts |
|
|
NOTE: There is a left and a right tool rest. Refer to Figure 1 |
|
|
|
to ensure that you install them correctly. When in actual use, |
|
|
|
the tool rests should be adjusted to within 1/4" of the grind- |
|
|
|
ing wheel or other accessory being used. |
| Washers Right | |
INSTALLING THE SPARK GUARDS AND EYE SHIELD |
| ||
BRACKETS |
|
| tool rest |
Turn off and unplug the bench grinder. |
|
| Fig. 1 |
The spark guards are packed in the plastic bag shipped with |
|
| |
your grinder. Select from the bag, the two spark guards and | Right |
| Fig. 2 |
the two smaller bolts and washers. Install the spark guards |
| ||
to the wheel guards of your grinder as shown in Figure 2. | spark |
|
|
guard |
|
| |
Adjust them to within 1/16" of the grinding wheel or other |
|
|
|
accessory being used. | Bolt |
|
|
NOTE: There is a left and right spark guard. Refer to |
|
| |
Figure 2 to ensure, that you install them correctly. | Washer |
|
|
INSTALLING THE EYE SHIELDS |
|
|
|
Flat | Bracket |
| |
Turn off and unplug the bench grinder. | Right | ||
Remove all remaining parts from the plastic bag. | Long washer | ||
NOTE: There is a left and a right eye shield mounting rod. | bolt |
| mounting |
|
| rod | |
Examine the figure closely to ensure that you are installing |
|
| Fig. 3 |
them correctly. |
|
|
|
The one pictured in Figure 3 is for the right wheel guard as | Eye shield mounting | Fig. 4 | |
you face the front of the tool. | |||
Carefully examine Figure 3 and assemble one rod, one | rod assembly |
|
|
bracket, one bolt and one flat washer as shown. When it |
|
|
|
has been assembled as shown in the figure, install it to the wheel guard of the grinder.
Position it with the arm high, as shown in Figure 4. and tighten the bolt securely.
5