Grizzly G0717 owner manual Assembly, To assemble your machine

Assembly

Assembling the G0717 requires connection of the control panel to the top of the saw bow and instal- lation of the motor and pulley cover.

To assemble your machine:

1.Remove the two hex bolts and washers shown in Figure 10 from the top of the saw bow.

Hex Bolts & Washers

Figure 10. Remove hex bolts.

2.Remove any remaining packing material from around the control panel, then place it in posi- tion on top of the saw bow, being careful not to twist the cords/hoses.

3.Secure the control panel as shown in Figure 11, using the hardware removed in Step 1.

Control Panel

Hex Bolts &

Washers

Figure 11. Attaching control panel.

-16-

4.Remove the motor pivot pin from the saw bow (See Figure 12 for location).

Pin Hardware

Motor

Pivot Pin

Figure 12. Mounting motor.

5.With the help of one or more assistants, lift the motor into position and re-insert the motor pivot pin.

6.Secure the motor pivot pin with the hardware removed in Step 4 (See Figure 12).

7.Place the belt over the pulleys.

8.Remove the hex bolt shown in Figure 13.

Hex Bolt

Figure 13. Motor adjustment bolt.

9.Rotate the motor tilt plate upward until it aligns with the hole from which the hex bolt was removed in Step 8, then re-install the hex bolt.

10.Tension the belt according to Step 5 in V-Belton Page 43.

Model G0717 (Mfg. Since 9/10)