Grizzly Model H5698 Operations, Test Run, To test run the Model W1713, do these steps

Page 18

OPERATIONS

Test Run

Once assembly is complete, the machine is ready for a test run. The purpose of a test run is to identify any unusual noises and vibrations, as well as to confirm that the machine is perform- ing as intended.

To test run the Model W1713, do these steps:

1.Make sure that all tools have been removed from the scroll saw.

2.Turn the variable speed/power knob clock- wise to turn the scroll saw ON.

3.Once the scroll saw is running, listen for any unusual noises. The machine should run smoothly with little or no vibrations.

If there are any unusual noises or vibra- tions, stop the scroll saw immediately by pushing the paddle switch down.

4.Unplug the scroll saw and investigate the source of the noise or vibration. DO NOT make any adjustments to the scroll saw while it is plugged in. The scroll saw should not be run any further until the problems are corrected.

OPERATIONS

THIS MACHINE throws wood chips and sawdust. Wear safety glasses or a face shield during all operations.

KEEP loose clothing rolled up and out of the way of machinery and keep hair pulled back.

THIS MACHINE produces sawdust that may cause allergic reactions or res- piratory problems. Wear a respirator in addition to using a dust collector.

-16-

Image 18
Contents Scroll Saw Page Contents Woodstock Service And Support IntroductionAbout Your New Scroll Saw Warranty And Returns SpecificationsSafety Standard Safety InstructionsResistant lenses, they are not safety glasses Injury. Always wear safety glasses or gogGles when operating equipment. Everyday Be certain the safety glasses you wear meetSafety Know Your MachineSafety Instructions for Your Scroll Saw Extension Cords Electrical Requirements110V Operation GroundingAssembly UnpackingInventory Initial Cleaning Shop PreparationDust Collection Table Prep To install the blade guard, do these stepsMounting Scroll Saw Blade GuardInstalling Pin-End Blades To install a pin end blade, do these stepsInstalling Pain-End Blades To install a plain end blade, do these stepsTo adjust the sawdust blower, do these steps AdjustmentsTo adjust the drop foot, do these steps Drop FootBlade Tension To adjust the blade tension, do these stepsScale Calibration To calibrate the scale, do these stepsOperations Test RunTo test run the Model W1713, do these steps Blade Speed Important issues regarding blade perfor- manceBlade Information Blade Selection TableTo perform a standard scroll cutting opera- tion Standard Scroll CuttingInterior Scroll Cutting To perform an interior scroll cutting opera- tionArm Bearings MaintenanceGeneral Motor BrushesClosure Parts Description Warranty Card BOX BELLINGHAM, WA