Grizzly Model H5698 instruction manual Standard Scroll Cutting, Interior Scroll Cutting

Page 20

Standard Scroll

Cutting

To perform a standard scroll cutting opera- tion:

For standard scroll cutting, follow the pattern lines on the workpiece by pushing and turning the workpiece at the same time. DO NOT turn the workpiece without pushing it at the same time; otherwise, the blade could twist and break.

OPERATIONS

Interior Scroll

Cutting

The scroll saw can also make internal scroll cuts without having to cut through the perimeter of the workpiece.

To perform an interior scroll cutting opera- tion:

1.UNPLUG THE SCROLL SAW!

2.Remove the saw blade.

3.Drill a 1⁄4" hole in the workpiece.

4.Place the hole in the workpiece over the blade hole in the table insert.

5.Re-install the blade by sliding the bottom end of the blade through the workpiece hole. Note—If a plain end blade is being used, the lower blade adapter may need to be installed after the blade is slid through the workpiece.

6.Adjust the drop foot onto the surface of the workpiece.

7.Plug the scroll saw in and perform the cut- ting operation.

8.When the cutting operation is complete, unplug the scroll saw and remove the saw blade.

-18-

Image 20

Contents Scroll Saw Page Contents About Your New Scroll Saw Woodstock Service And SupportIntroduction Warranty And Returns SpecificationsSafety Standard Safety InstructionsInjury. Always wear safety glasses or gog Gles when operating equipment. EverydayResistant lenses, they are not safety glasses Be certain the safety glasses you wear meetSafety Know Your MachineSafety Instructions for Your Scroll Saw Electrical Requirements 110V OperationExtension Cords GroundingInventory AssemblyUnpacking Dust Collection Initial CleaningShop Preparation To install the blade guard, do these steps Mounting Scroll SawTable Prep Blade GuardInstalling Pin-End Blades To install a pin end blade, do these stepsInstalling Pain-End Blades To install a plain end blade, do these stepsAdjustments To adjust the drop foot, do these stepsTo adjust the sawdust blower, do these steps Drop FootTo adjust the blade tension, do these steps Scale CalibrationBlade Tension To calibrate the scale, do these stepsTo test run the Model W1713, do these steps OperationsTest Run Important issues regarding blade perfor- mance Blade InformationBlade Speed Blade Selection TableStandard Scroll Cutting Interior Scroll CuttingTo perform a standard scroll cutting opera- tion To perform an interior scroll cutting opera- tionMaintenance GeneralArm Bearings Motor BrushesClosure Parts Description Warranty Card BOX BELLINGHAM, WA