Grizzly G9743 owner manual Wheels, Chip Screen, To install the wheels, To install the chip screen

Wheels

The wheels may be installed to make it easier to move the G9743 bandsaw.

Components and Hardware Needed:	Qty
Wheels	2
Wheel Brackets	2
Axles	2
Hex Bolts 3⁄8-16 x 5⁄8	2
Flat Washers 3⁄8	2
Cotter Pins 3 x 25	2
Hex Bolts 5⁄16-18 x 11⁄2	6
Hex Nuts 5⁄16-18	6
Flat Washers 5⁄16	12
To install the wheels:

1.Align a wheel bracket with the frame mount- ing holes and secure with three 5⁄16-18 x 11⁄2 hex bolts, three hex nuts, and six flat wash- ers, as shown in Figure 8.

Wheel Bracket

Axle

Figure 8. Installing wheel.

2.Insert the threaded end of each axle into the wheel bracket and secure with a 3⁄8-16 x 5⁄8 hex bolt and a flat washer.

3.Slide a wheel over the axle.

4.Insert a cotter pin into the axle, and spread the pin to secure the wheel.

5.Install the opposite wheel, repeating Steps 1–4.

G9743 7" x 12" Metal-Cutting Bandsaw

Chip Screen

The chip screen is designed to prevent chips and cut-offs from entering the coolant tank.

Components and Hardware Needed:	Qty
Chip Screen	1
To install the chip screen:

1.Place the chip screen into the opening shown in Figure 9.

Chip screen

Figure 9. Chip screen installed.

-17-